RCU Forums - View Profile: jaka

Go Back  RCU Forums >
Reload this Page >

jaka's Profile

Community
Search
Notices

jaka jaka is offline

About Me

  • About jaka
    Location
    Upplands Vasby, SWEDEN
  • Signature
    Jan Karlsson - Supplier MVVS Products

Statistics

Total Posts
Visitor Messages
Total Likes
General Information
  • Last Activity: 12-24-2020 08:51 AM
  • Join Date: 12-11-2001

Visitor Messages

Showing Visitor Messages 1 to 5 of 5
  1. 04-28-2024 07:42 PM
    Hello Jaka (Jan),

    I'm fredman2 (Fred) and have been trying to gather info from past searches on MVVS 10cc and 12cc glow engines. In research I noticed that some of the MVVS engines have the ability to convert from side exhaust to rear exhaust. I'm looking at used 10 & 12cc and 15cc engines, do all of these convert from side to rear exhaust. I don't see many 15's and I'm also looking for pdf's or pictures of the "instructions" for these. If you could advise me I'd be very appreciative. Thanks for any help here, there aren't many people that have MVVS knowledge. Fred
  2. 11-02-2019 05:31 AM
    Hello Jan
    They still have spare parts for engines MVV
    I am searching the Caburetor for 10cc MVVS
    The Partsnumber is 3219 (the last execution)

    Regards Bernd
  3. Phaedra
    10-04-2019 10:35 PM
    Hello Jan,

    thank you for the clear reply.
    Since we will be having to do some renovations in the house this winter, I won't be able the start the build immediately. As such, it won't be a problem for me to wait for a while.

    I will be in touch, thank you!

    Phaedra
  4. Phaedra
    10-03-2019 01:24 AM
    Hello Jan,

    I purchased a Royal C-47 kit a couple of years ago, and I'm considering to start the build soon. I read about the cowls and nacelles that you built for this model, and I would be very interested in buying a set of those from you. Would you be willing to make and sell a set to me? And how much would that cost? (I live in Belgium, so not that far away...)

    Thank you,

    Phaedra
  5. 07-14-2019 04:54 PM
    HeyJaka. thanks for the post re: 3 Blade props on my FW190

    Can I ask why you would recommend the 14x6 APC? Have you done testing on the same? What were the results?

    I would have to change my spinner setup so I would need a good reason to swap over.

    I have a 13x6 3-blade as a backup.

    I am doing tacho testing this week to see how the 13x8 x 3blade on the stock muffler goes.

Contact Us - Manage Preferences Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.