Cox .020 powered flying wing
#1
Cox .020 powered flying wing
Here it is all done [well done enough Smile ]
24 inch span and a little less than 6 ounces
I needed to add some weight to the tail to set the CG at 15%.
I pounded a length of solder flat, then glued it to the fin.
The model flew pretty straight and stable with enough elevator during the glide to flare the landings at a low enough speed.
Run time was almost 3 minutes with a little less than a 1/2 oz fuel tank.
24 inch span and a little less than 6 ounces
I needed to add some weight to the tail to set the CG at 15%.
I pounded a length of solder flat, then glued it to the fin.
The model flew pretty straight and stable with enough elevator during the glide to flare the landings at a low enough speed.
Run time was almost 3 minutes with a little less than a 1/2 oz fuel tank.
The following users liked this post:
mgnostic (Today)