Help with my first helicopter
#1
Junior Member
Thread Starter
Join Date: Oct 2024
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Help with my first helicopter
I purchased a Goosky Rs4 Venom for my first 3d helicopter and my first kit well I followed everything to a T from helidirect and some videos building /setting it up ect.. We I tried the Maiden flight the other day and on spool up 3 times in a row it spun out of control I'm going to recenter my pitch on the tail I had two 2° of right pitch to counter the torque but I think it's too much so I'm going to try to center it and see if that fixes it. But would it be my gain on my gryo or something else possible I'm really new to building my. Own chopper. Most I've ever done was RTF's any advice would help me figure out why in normal mode on spool up it spins.
#2
Check that the tail motor is rotating in the correct direction. Check that the fbl unit is correcting in the right direction. Check that left/right is correct in TX. Check that the tail blade was put on in the correct direction. Take the main blades off until you get it working correctly.
#3
Junior Member
Thread Starter
Join Date: Oct 2024
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Check that the tail motor is rotating in the correct direction. Check that the fbl unit is correcting in the right direction. Check that left/right is correct in TX. Check that the tail blade was put on in the correct direction. Take the main blades off until you get it working correctly.