TMMY Scale Composites 35% scale Cessna
#2003
I have not gotten that far but if your back through the thread I am sure others have posted what they have done.
I'd also research what settings the full size uses, given the size of this model that would be a good place to start.
I'd also research what settings the full size uses, given the size of this model that would be a good place to start.
#2004
Thread Starter
My Feedback: (23)
Saul
The following users liked this post:
Super18 (08-11-2024)
#2007
your dash is a lot better than the one I got. Original owner must have told them to just supply an old steam gauge dash.
I will make a new one.
Mine is deferred for the time being, still waiting on the brakes and associated hub machining.
I will make a new one.
Mine is deferred for the time being, still waiting on the brakes and associated hub machining.
The following 2 users liked this post by scottkieper:
planenutzz (08-29-2024),
Super18 (08-30-2024)
#2017
came out nice, well done. Instrument panel does look good. Mine is on hold till I get the brakes sorted, friend is doing machining for me.
I need to get all the G1000 surrounds etc for mine, was going to get somebody to program up some functional ones but think it will be too expensive to do.
One thing to watch is with the seats, they are quite flimsy at the outside of the bend and will crack. I am going to put a layer of either carbon fiber or 6oz cloth to that area.
What size fuel tank did you put in?
cheers
P
I need to get all the G1000 surrounds etc for mine, was going to get somebody to program up some functional ones but think it will be too expensive to do.
One thing to watch is with the seats, they are quite flimsy at the outside of the bend and will crack. I am going to put a layer of either carbon fiber or 6oz cloth to that area.
What size fuel tank did you put in?
cheers
P