Starting problems rabbit 100
#1
Thread Starter
My Feedback: (5)
Join Date: May 2005
Location: dunn,
NC
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Starting problems rabbit 100
I started up my rabbit for the 1st last night, and after the 3-4 step it shut down ..... And it was reading Idol ERROR???? Was this something I did wrong when I paired up my transmitter? If so how can I fix it?
#3
My Feedback: (44)
Not sure what you mean about 3-4 step?
Are you talking about Preheat stage to Switchover?
Is this a new Rabbit ?
Which electronics does it have? Powerpak SP or Powerpak SE
Did you review the manual?
If you need to talk to someone directly from Jet Central you can call the US rep:
Jose Melendez
231 Anthony Ave SE
Palm Bay Florida 32909
321-412-3078
[email protected]
Are you talking about Preheat stage to Switchover?
Is this a new Rabbit ?
Which electronics does it have? Powerpak SP or Powerpak SE
Did you review the manual?
If you need to talk to someone directly from Jet Central you can call the US rep:
Jose Melendez
231 Anthony Ave SE
Palm Bay Florida 32909
321-412-3078
[email protected]
#5
Join Date: Nov 2003
Location: Mexico CityD.F., MEXICO
Posts: 253
Likes: 0
Received 6 Likes
on
4 Posts
"To Idle Error" means that turbine is not getting to idle on a pre programed time
To avoid that you only need to increase the fuel a little
Go to Start menue and increase the initial fuel a couple of points and one point in the fuel ramp
That should solve the problem
Regards
#7
Thread Starter
My Feedback: (5)
Join Date: May 2005
Location: dunn,
NC
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Hello Baldhead
"To Idle Error" means that turbine is not getting to idle on a pre programed time
To avoid that you only need to increase the fuel a little
Go to Start menue and increase the initial fuel a couple of points and one point in the fuel ramp
That should solve the problem
Regards
"To Idle Error" means that turbine is not getting to idle on a pre programed time
To avoid that you only need to increase the fuel a little
Go to Start menue and increase the initial fuel a couple of points and one point in the fuel ramp
That should solve the problem
Regards
#8
Join Date: Nov 2003
Location: Mexico CityD.F., MEXICO
Posts: 253
Likes: 0
Received 6 Likes
on
4 Posts
Hello
Please do the auto calibration procedure:
Start the turbine and leave it at idle until you get the "Min Pump Ok" message
Go slowly to full throttle and leave it there until get "Max Pump Ok" and you are done
If you need more detailed information of these procedure please refer to the manual
We recommend to do this procedure every time that you recharge batteries or if change something in your airplane fuel system
Regards
Please do the auto calibration procedure:
Start the turbine and leave it at idle until you get the "Min Pump Ok" message
Go slowly to full throttle and leave it there until get "Max Pump Ok" and you are done
If you need more detailed information of these procedure please refer to the manual
We recommend to do this procedure every time that you recharge batteries or if change something in your airplane fuel system
Regards