EZE-KOTE and epoxy compatible?
#1
Thread Starter
My Feedback: (4)
Join Date: Jan 2002
Location: Prague, CZECH REPUBLIC
Posts: 4,144
Likes: 0
Received 0 Likes
on
0 Posts
EZE-KOTE and epoxy compatible?
I'm using EZE-KOTE to laminate and would like to use epoxy resin over it (once dried for couple of days) in some arias.
Will it work ?
Thanks
Will it work ?
Thanks
#2
It should be compatible.
You need to wait longer than a couple days, though. Many think that water borne products dry quickly, but that is not always the case.
I suggest that you wait at least a week. Longer, if possible. If you put your epoxy over it before it is completely dry, you may trap a small amount of water under it. When the model is placed in the sun, heat turns the water into vapor, causing blisters.
You need to wait longer than a couple days, though. Many think that water borne products dry quickly, but that is not always the case.
I suggest that you wait at least a week. Longer, if possible. If you put your epoxy over it before it is completely dry, you may trap a small amount of water under it. When the model is placed in the sun, heat turns the water into vapor, causing blisters.