CARF F4U-1 Corsair build thread
#3876
Join Date: Aug 2010
Location: Monterey, CA
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Hey Carf Corsair folks, I have an engine standoff question. I see here, in this thread, the different standoff lengths to get the 2.5 degrees of right and .5 degrees of upthrust (according to the Carf manual). My question is about the faces of the actual standoffs. Are you all making them square and just not worrying about the “tweaking” on the motor flanges? Or are you machining the angles onto the faces, the matching angles on washers? Thanks for some insight / education.