GIANT Indoor/Outdoor 3/D Pattern
#1
Thread Starter
Join Date: Nov 2010
Location: Coffs Harbour NSW, AUSTRALIA
Posts: 1,650
Likes: 0
Received 72 Likes
on
68 Posts
GIANT Indoor/Outdoor 3/D Pattern
After all the success with my huge micro light, skeleton type 3/D Pattern fleet, I have decided to create a GIANT version. Using 6mm Depron sheets I have drawn and cut out a new frame at 120x165 cm all up size, reinforced with some 30 meters variety of finest Carbon Fiber rods, currently fitted with a slow 22 series 740kv AXI outrunner off a small 2S packs spinning 13x4.7 SF prop before I can get something larger OD with minimal pitch to slow it even further.
Real delight model to fly,
(Giant 3/D Pattern test run)
Size comparison to my largest Carbon frame design.
Early stage of the new project.
Gradual progress, top fuse half alignment.
Carbon bracing.
New colour scheme.
Ready for maiden flight.
AMEN.
intended mainly for large indoor stadium but during the current work on the complex I started flying it outdoors to keep it up.
Real delight model to fly,
Size comparison to my largest Carbon frame design.
Early stage of the new project.
Gradual progress, top fuse half alignment.
Carbon bracing.
New colour scheme.
Ready for maiden flight.
AMEN.
intended mainly for large indoor stadium but during the current work on the complex I started flying it outdoors to keep it up.
#5
Thread Starter
Join Date: Nov 2010
Location: Coffs Harbour NSW, AUSTRALIA
Posts: 1,650
Likes: 0
Received 72 Likes
on
68 Posts
Summer is here, making most of this fabulous Skeleton Giant, indoors or outdoors, now running immaculate on my new scratch build Composite/Laminate Props.
Having a ball in the bowl.
Indoor at Coffs.
Immaculate run on new scratch built prop.
Having a ball in the bowl.
Indoor at Coffs.
Immaculate run on new scratch built prop.