Servo travel no equal
06-06-2008, 08:33 AM
#1
Senior Member
Thread Starter
Join Date: Nov 2005
Location: albuquerque,
NM
Posts: 312
Likes: 0
Received 0 Likes
on
0 Posts
Servo travel no equal
I got a few part in a trade and one is a nice high torque servo. But I noticed that the servo travel a lot further in one direction than the other. I check my EPA setting on my radio and they were good and the servo hssnt been installed yet so there is no load on ther servo to hold it back. I cant hear any clicking that would make me think it had broken gear. Is the servo going bad? The servo is JR 9000T.
