JR XS3
#1
Senior Member
Thread Starter
Join Date: Nov 2007
Location: Garner,
IA
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
JR XS3
I don't really get this, i thought these were supposed to search for signals and automatically pick a freguency. JR you change the freguency on the radio and the reciver between 61-90 i think. its like its crystalless but not 2.4, is it?
Im also having some problems with it, the car will take off by itself and keep going for 5-10 seconds and then stop and you can continue driving, whats happening??
Its doing it to my dads too, not as bad, but his is brand new, only been ran a few times.
On mine it didnt start right away but when it did it wasnt nearly this bad.
can someone help?
Im also having some problems with it, the car will take off by itself and keep going for 5-10 seconds and then stop and you can continue driving, whats happening??
Its doing it to my dads too, not as bad, but his is brand new, only been ran a few times.
On mine it didnt start right away but when it did it wasnt nearly this bad.
can someone help?
#2
Senior Member
Join Date: Jan 2005
Location: Manchester, UNITED KINGDOM
Posts: 3,779
Likes: 0
Received 1 Like
on
1 Post
RE: JR XS3
The XS3 is available in three flavours - 27, 40 and 75mhz. As you're from the US yours will either be 27 or 75mhz as the 40mhz band is only used in Europe I believe.
Try setting the Tx and Rx to a different frequency and see if that makes a difference. The manual may also have some troubleshooting tips - check that out.
Try setting the Tx and Rx to a different frequency and see if that makes a difference. The manual may also have some troubleshooting tips - check that out.