Where is AMT USA ?
01-12-2009, 07:39 PM
#2
Join Date: Jan 2002
Location: Waterford,
MI
Posts: 253
Likes: 0
Received 0 Likes
on
0 Posts
RE: Where is AMT USA ?
AMT USA is now US Microjet and they are very much still in buisness.
www.usmicrojet.com
Go here for more details:
http://www.rcuniverse.com/forum/m_80...key_AMT/tm.htm
Email address: [email protected]
www.usmicrojet.com
Go here for more details:
http://www.rcuniverse.com/forum/m_80...key_AMT/tm.htm
Email address: [email protected]
01-16-2009, 10:04 PM
#10
Senior Member
My Feedback: (60)
Join Date: Feb 2002
Location: Tinley Park,
IL
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
RE: Where is AMT USA ?
Id3m,
As Randy said the Factory Specs are between 18 and 20 pounds, I will check with the factory to see if they have a file on that engine.
Do you know what the Maximum RPM is set to on that ECU?
John
As Randy said the Factory Specs are between 18 and 20 pounds, I will check with the factory to see if they have a file on that engine.
Do you know what the Maximum RPM is set to on that ECU?
John
01-17-2009, 01:00 AM
#11
My Feedback: (44)
Join Date: Jan 2002
Location: Mother Earth, the Sunny side!
Posts: 1,882
Likes: 0
Received 0 Likes
on
0 Posts
RE: Where is AMT USA ?
This engine was up for sale on the classified, hence he has to run the engine to know the rpm (gen1?) unless he already bought it and ran it...[8D]
01-17-2009, 09:15 AM
#13
My Feedback: (13)
RE: Where is AMT USA ?
If I am not mistaken, the 180SP had some different internal parts to handle the higher heat and output. I have had a Mercury or two since 1998. The original Mercury RPM was set at around 142-144K for about 16# of thrust. The next step was to 147k for approx 18# of push. The 180sp were set to approx 152k for the 20-21 of thrust. However almost any turbine's thrust will vary somewhat. It all depends on each particular motor. Some will put out a liitle more, depending on the internal tolerances etc. . Some turbines just put out a liitle more than others!
Ron
Ron
