Harlock RC Viper 140
#54
Thank you.
#56
My Feedback: (3)
Enya .19 on the front of a Goldberg Falcon 56, Kraft FM radio on 53MHz.
Rudder and Elevator, hand launch, no throttle servo
Back then CG was the last thing on my
mind ... I was thinking how long 5 minute epoxy would take to cure sitting on a bench between flights (crashes) so I could get back up in the air
#57
My Feedback: (53)
I started flying back in 1974
Enya .19 on the front of a Goldberg Falcon 56, Kraft FM radio on 53MHz.
Rudder and Elevator, hand launch, no throttle servo
Back then CG was the last thing on my
mind ... I was thinking how long 5 minute epoxy would take to cure sitting on a bench between flights (crashes) so I could get back up in the air
#58
Se above 4min on 30oz with the K45.... if the K30 performs anywhere near a Kolibri it will easily do 7min on 28oz.
#59
My Feedback: (4)
Join Date: Jan 2005
Location: Pensacola,
FL
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Mine flew today.
Swiwin 60
jeti 12 assist
HSD retracts
custom dual wall pipe
MKS 69&63
exceeded expectations. 60N allows for very short take offs and vertical acceleration as far as you can see it. I could fly 6:30-7 with plenty of reserve due to 1/4-1/3 throttle for most level flight. Ballistic if you want. Fits in car put together for quick trips to field. This plane will see lots of flight time.
Swiwin 60
jeti 12 assist
HSD retracts
custom dual wall pipe
MKS 69&63
exceeded expectations. 60N allows for very short take offs and vertical acceleration as far as you can see it. I could fly 6:30-7 with plenty of reserve due to 1/4-1/3 throttle for most level flight. Ballistic if you want. Fits in car put together for quick trips to field. This plane will see lots of flight time.
#61
Mine flew today.
Swiwin 60
jeti 12 assist
HSD retracts
custom dual wall pipe
MKS 69&63
exceeded expectations. 60N allows for very short take offs and vertical acceleration as far as you can see it. I could fly 6:30-7 with plenty of reserve due to 1/4-1/3 throttle for most level flight. Ballistic if you want. Fits in car put together for quick trips to field. This plane will see lots of flight time.
Swiwin 60
jeti 12 assist
HSD retracts
custom dual wall pipe
MKS 69&63
exceeded expectations. 60N allows for very short take offs and vertical acceleration as far as you can see it. I could fly 6:30-7 with plenty of reserve due to 1/4-1/3 throttle for most level flight. Ballistic if you want. Fits in car put together for quick trips to field. This plane will see lots of flight time.
Regards.
#62
My Feedback: (4)
Join Date: Jan 2005
Location: Pensacola,
FL
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
A friend of mine made it from the single wall pipe by spot welding the spacer and new inner pipe together. I didn’t like the single wall set up of the conversion kit. The tail is cool during start up and shutdown so I definitely would recommend. I might have drawing and assemble information if you are interested. Unfortunately I don’t think he wants to go into business.
#63
A friend of mine made it from the single wall pipe by spot welding the spacer and new inner pipe together. I didn’t like the single wall set up of the conversion kit. The tail is cool during start up and shutdown so I definitely would recommend. I might have drawing and assemble information if you are interested. Unfortunately I don’t think he wants to go into business.
Last edited by jcpl; 01-06-2019 at 05:02 PM. Reason: mistake
#67
My Feedback: (2)
FYI everyone, I've heard others talk about the HSD brakes are crap, but no one explained it was cause there NOT proportional. I'm not one to waste money on unnecessary equipment , but I ordered the xicoy brake controller. Another set back but should be ready for a Maiden flight by this weekend. I promise no more small jets after this one getting everything to fit is a struggle. Hopefully it balances as I refuse to add weight and I don't have very many places to move my batteries (I always make batteries removable for charging). I did end up adding 8 oz tank right behind wing tube. 42 -43 oz with a jetmunts 70XBL should have plenty of flight time I hope.
#68
My Feedback: (11)
FYI everyone, I've heard others talk about the HSD brakes are crap, but no one explained it was cause there NOT proportional. I'm not one to waste money on unnecessary equipment , but I ordered the xicoy brake controller. Another set back but should be ready for a Maiden flight by this weekend. I promise no more small jets after this one getting everything to fit is a struggle. Hopefully it balances as I refuse to add weight and I don't have very many places to move my batteries (I always make batteries removable for charging). I did end up adding 8 oz tank right behind wing tube. 42 -43 oz with a jetmunts 70XBL should have plenty of flight time I hope.
#71
My Feedback: (11)
Turbine placement
Hi All,
I have a couple questions.
1. Is your turbine cone 20-30mm inside the pipe? This does not seem correct. I followed the turbine conversion manual. (See my install)
2. Are there any thrust angle adjustments needed?
3. Where are you placing the fuel pump and ECU battery?
Thank you,
Last edited by F16Jeff; 01-12-2019 at 06:08 PM.
#73
My Feedback: (53)
Hi All,
I have a couple questions.
1. Is your turbine cone 20-30mm inside the pipe? This does not seem correct. I followed the turbine conversion manual. (See my install)
2. Are there any thrust angle adjustments needed?
3. Where are you placing the fuel pump and ECU battery?
Thank you,
2- look inside the tail pipe and if the motor is not center......then you need to adjust/shim to center it.
3- As far as possible to the Receiver/antenna.....where ever it fit...and can achieve a proper C&G.
#75
My Feedback: (2)
So got mine maidened (twice, Plumbing issue caused a flame out) plus now 5 flights. A grand total of 7 flights. Setup is KST 215mg servos 2x 2s2500 mah LiPO batteries (one for receiver gear and brakes one for turbine) M70 XBL turbine Jeti Rex 12 assist (built in gyro). I had the xicoy brake controller in it, but it burned up after I left the brakes on for a long period of time. I went back to the trusty Jp brake controller I have used for a while now. Still proportional but doesn't have the ABS system. I have the 100ml FCT UAT,stock tank plus an 8 oz tank underneath giving me right at 7 minutes of invigorating flying. Balance is at 213mm. It may be a little tail heavy there but I'm allergic to adding weight to a model. Only place I notice is when I try and do inverted outside loops it snaps out of it. Despite the very narrow wing it lands very slow almost walking speed and hasn't dropped a wing on me yet. I was getting wing rock on it just flying around but the gyro cleaned it up so I'm not worried about it. I will say she isn't quite as fast as my ultraflash with a 140 in it but from a stand still she shoots out like a rocket and is still faster then my 1.7m T-1. She gets small in a hurry and I'm sure glad I got the orange one as I can see it well even on crappy days. She's my second favorite at the moment, only surpassed by my T-1 as my favorite, but at half the cost it's a steal.
Last edited by jesse2357; 02-16-2019 at 09:18 AM.