YS-63 Drive hub
#1
Thread Starter
My Feedback: (65)
Join Date: May 2002
Location: Tulare,
CA
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
YS-63 Drive hub
Does anyone make a hub extension for this series of YS. I know its probably not rocommended but before I go forth and machine one myself I was hoping for some input on an available one out there. look to extend about 1".
Any help greatly appreciated.
Paul
Any help greatly appreciated.
Paul
#3
Thread Starter
My Feedback: (65)
Join Date: May 2002
Location: Tulare,
CA
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
RE: YS-63 Drive hub
In essence a drive washer to relocate the propellor further out approximately an inch. Couple of companies make them for gasoline engines but dont for these smaller engines. Probably will just have to fabricate one from bar-stock......dust off my machining skills.
Thanks for the input
Paul
Thanks for the input
Paul