Vampower Issue
07-01-2024, 12:19 AM
#1
Junior Member
Thread Starter
Join Date: May 2024
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Vampower Issue
Hello everyone.
I'm having issues with my approximately 3 - 5 yr old charger this season. It charges my lipos with no issue. However, I've cooked 2 of my Nimh batteries this season now. It never seems to sense the peak charge for some reason. I usually ran the voltage sensitivity at 5mv, but changed that to default. I believe default is 3mv, but not 100% certain. I already purchased a new 6.0 volt 2,150 mah battery for my Futaba 14SG. I've discharged to .9volts /cell. Charged back up, and it has put in 2,500mah and was still going. I had the capacity cutoff on, set to 2,500 in this case which saved it. I'm not sure why peak is not getting detected.
Any help?
I'm having issues with my approximately 3 - 5 yr old charger this season. It charges my lipos with no issue. However, I've cooked 2 of my Nimh batteries this season now. It never seems to sense the peak charge for some reason. I usually ran the voltage sensitivity at 5mv, but changed that to default. I believe default is 3mv, but not 100% certain. I already purchased a new 6.0 volt 2,150 mah battery for my Futaba 14SG. I've discharged to .9volts /cell. Charged back up, and it has put in 2,500mah and was still going. I had the capacity cutoff on, set to 2,500 in this case which saved it. I'm not sure why peak is not getting detected.
Any help?
