Aerohawk mixer/gyro board
#1
Junior Member
Thread Starter
Join Date: Feb 2004
Location: , UNITED KINGDOM
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Aerohawk mixer/gyro board
Hiya all,
Has anyone got a close-up picture of the Aerohawk mixer/gyro board? I bought my heli second hand, and have noticed that the three wire bus (black/red/white) cable that goes from the mixer board to the receiver board that the cable appears to have the red (middle) wire badly removed.. looking like it has been ripped out? the alternative is if someone can confirm that this is correct. the cable is the one in between the two silver tant capacitors.
cheers
lee
Has anyone got a close-up picture of the Aerohawk mixer/gyro board? I bought my heli second hand, and have noticed that the three wire bus (black/red/white) cable that goes from the mixer board to the receiver board that the cable appears to have the red (middle) wire badly removed.. looking like it has been ripped out? the alternative is if someone can confirm that this is correct. the cable is the one in between the two silver tant capacitors.
cheers
lee
#3
Junior Member
Thread Starter
Join Date: Feb 2004
Location: , UNITED KINGDOM
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
RE: Aerohawk mixer/gyro board
Hiya, thanks for photo.. really need to know how the wiring is inbetween the two silver caps.. so I can see how it has been wired.
Thanks
Lee
Thanks
Lee
#4
Senior Member
Join Date: Jan 2004
Location: Bardufoss, NORWAY
Posts: 625
Likes: 0
Received 0 Likes
on
0 Posts
RE: Aerohawk mixer/gyro board
The signal wires for the tail channel should only be black and white because you don't need two ESCs feeding the receiver with +