GWS Transmitter(piccolo fun problems)
#1
Junior Member
Thread Starter
Join Date: Aug 2004
Location: Peterlee, UNITED KINGDOM
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
![Default](images/icons/icon1.gif)
Does anyone know how to setup up the channels on a Ikarus board, with this Tramsmitter?.. i can`t seem to get anything to work, as the manual is pants to put it plainly, as the manual gives me diagrams and instructions, that don`t coincide with the equipment that i got with the piccolo..
thx in advance
dazza
thx in advance
dazza
#2
#3
Member
My Feedback: (8)
Join Date: Dec 2002
Location: Cape Coral,
FL
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
![Default](images/icons/icon1.gif)
I have the GWS GWT-4A transmitter so here goes,
On my gws RX,(GWR-4P) connections as follows:
ch 1-there are two wires from piccobd that connect to rx(receiver).
when piccobd is mounted in correct position, the top wire goes to ch-1.
ch2- connects to servo that controls left/right.
ch3-connects to servo that controls forward and aft.
ch4- bottom wire from piccobd.
on TX(transmitter)- Channels 1 & 3 are reversed with small DIP switch.
Hope it helps...Bill
On my gws RX,(GWR-4P) connections as follows:
ch 1-there are two wires from piccobd that connect to rx(receiver).
when piccobd is mounted in correct position, the top wire goes to ch-1.
ch2- connects to servo that controls left/right.
ch3-connects to servo that controls forward and aft.
ch4- bottom wire from piccobd.
on TX(transmitter)- Channels 1 & 3 are reversed with small DIP switch.
Hope it helps...Bill