Low voltage cutoff source
#1
Junior Member
Thread Starter
Join Date: Apr 2002
Location: BELMONT, MI,
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Low voltage cutoff source
Have some turnigy lipos coming for a stock Slash. What is a good low voltge sensor to get, and from where?? Would like one with a buzzer along with the leds.
#2
Join Date: Jul 2007
Location: North West Indiana
Posts: 12,861
Likes: 0
Received 20 Likes
on
19 Posts
RE: Low voltage cutoff source
Well if its an XL-5 slash LVC's won't work, what you need is a low voltage alarm. They plug in the balance port of the battery.
Go to ebay type in "LiPo Low Voltage Alarm" around 100 will pop up
I've got the red with the single buzzer, and the greens with a single buzzer, they both work fine and will alarm when any cell his 3.4(or was it 3.2) Volts
Just a note they will NOT turn off the ESC, or give any feedback like slowing the motor it is mostly auditory (unless you can see the blinking LED's), but damn is that siren annoying I doubt you could stand running it for a minute after it alarms.
Go to ebay type in "LiPo Low Voltage Alarm" around 100 will pop up
I've got the red with the single buzzer, and the greens with a single buzzer, they both work fine and will alarm when any cell his 3.4(or was it 3.2) Volts
Just a note they will NOT turn off the ESC, or give any feedback like slowing the motor it is mostly auditory (unless you can see the blinking LED's), but damn is that siren annoying I doubt you could stand running it for a minute after it alarms.