aux 2 servo travel on DX7s
#1
Junior Member
Thread Starter
Join Date: Jun 2012
Location: SIMI VALLEY, CA
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
aux 2 servo travel on DX7s
I have a Nirtoplanes B-25 and I cannot seem to get the bomb bay doors to open correctly on channel 7 (aux 2) and i cannot figure out how to adjust the travel correctly on the screens. Everything else works just fine and it flys great. i HAVE TRIED EVERYTHING i CAN FIND ON THE SERVO ADJUSTMENT SCREEN AND I GET SOME DIFFERENCE IN MOVEMENT BUT NOT ENOUGH-HELP !! THANK YOU AL
#2
Senior Member
Join Date: Sep 2007
Location: Sanger,
CA
Posts: 427
Likes: 0
Received 0 Likes
on
0 Posts
RE: aux 2 servo travel on DX7s
In your Servo Setup screen you have Travel adjust.By default it is 100% in both directions from center.You can increase the travel up to 150%.
If ths still isnt enough travel you need to adjust linkage geometry to get more travel at the doors themselves.
Not sure exactly what you have going on from your description.How do you have the travel set now and exactly what is the problem your trying to solve?Doors dont completely open or close or both?
Do you have the Aux2 assigned to a switch or the knob?
If ths still isnt enough travel you need to adjust linkage geometry to get more travel at the doors themselves.
Not sure exactly what you have going on from your description.How do you have the travel set now and exactly what is the problem your trying to solve?Doors dont completely open or close or both?
Do you have the Aux2 assigned to a switch or the knob?