JR1222 Rx binding problem
08-11-2012, 11:20 AM
#1
Thread Starter
Join Date: Sep 2007
Location: Beeton, Ontario, CANADA
Posts: 1,357
Likes: 0
Received 7 Likes
on
6 Posts
JR1222 Rx binding problem
Hello... I have a JR 1222 with two 2700mha nickle 6v packs. I have a lot of experience with JR products but I cant seem to get this Rx to bind. Nothing happens? No lights at all. Both packs are fully charged and I have the bind plug in the correct location as per the instruction manual.
Please help. This is a brand new Rx right out the package and all 4 satilite Rx's are hooked up
Thanks
Please help. This is a brand new Rx right out the package and all 4 satilite Rx's are hooked up
Thanks
08-11-2012, 02:07 PM
#3
Thread Starter
Join Date: Sep 2007
Location: Beeton, Ontario, CANADA
Posts: 1,357
Likes: 0
Received 7 Likes
on
6 Posts
RE: JR1222 Rx binding problem
Yes Sir..
Dont know what happened.. But after many attempts and fiddling with the satilite wires.. I noticed that 3 started to blink. I then change the satilite on the forth and now its working fine.
Problem solved and Im not sure why.[
] I did notice though.. after turning the switch on, it would take a few seconds for the blue lights to appear. maybe it needed some time to charge? I dont know..I just know its working fine now.
Thanks
Dont know what happened.. But after many attempts and fiddling with the satilite wires.. I noticed that 3 started to blink. I then change the satilite on the forth and now its working fine.
Problem solved and Im not sure why.[
] I did notice though.. after turning the switch on, it would take a few seconds for the blue lights to appear. maybe it needed some time to charge? I dont know..I just know its working fine now.Thanks
