Details for Scale Canopy Sequencer Reset
10-16-2012, 12:37 PM
#2
RE: Details for Scale Canopy Sequencer Reset
Nobody??!!
OK, well, I found a thread where someone used a jetcat ECU to set the channel they wanted to use to set the ATV parameters so that the ECU registered an output between 1100-1800 and then the sequencer would work.
I'll try to call Dan at details for scale and post what he says.
OK, well, I found a thread where someone used a jetcat ECU to set the channel they wanted to use to set the ATV parameters so that the ECU registered an output between 1100-1800 and then the sequencer would work.
I'll try to call Dan at details for scale and post what he says.
10-24-2012, 10:09 AM
#4
RE: Details for Scale Canopy Sequencer Reset
Ok, so even Dan had it somewhat wrong, but he helped!!
With the TX, RX and standard sequencer on. Press BOTH SW1 and SW2 then turn off RX while keeping both SW1 and SW2 pressed, turn the RX back on and it will reset.
With the TX, RX and standard sequencer on. Press BOTH SW1 and SW2 then turn off RX while keeping both SW1 and SW2 pressed, turn the RX back on and it will reset.
10-24-2012, 03:10 PM
#5
Senior Member
My Feedback: (3)
Join Date: Dec 2007
Location: Comus,
MD
Posts: 299
Likes: 0
Received 0 Likes
on
0 Posts
RE: Details for Scale Canopy Sequencer Reset
Hold both buttons down and turn on the receiver, don't hold long. As soon as the receiver comes on, release immediately.
Richard
Richard
