twin motor throttle linkage, single vs dual servo?
#1
Thread Starter
twin motor throttle linkage, single vs dual servo?
Ok folks, this may have been addressed earlier but we all know how the search engine here is. Working on a PI fountain 53" and running 2 single inline 26cc motors. Here's the question, any preferences on running dual servo's(1) for each carb or a single servo with linkage? Only running a 3ch basic TX so mixing isn't going to happen. Any thoughts or pics would be greatly appreciated.
Last edited by TheBennyB; 10-23-2016 at 05:52 AM.
#3
Join Date: Dec 2008
Location: Ocala, Fl
Posts: 689
Likes: 0
Received 0 Likes
on
0 Posts
One servo is all you need but two servo is not a bad way especially if you wire and program them in the computer radio with one on channel 2 (master)and one on channel 3 (slave) this gives you individual trims for both engines.
One is a better way. IMO.
One is a better way. IMO.