Binding a dx2 spectrum transmitter
#1
Junior Member
Thread Starter
Join Date: Dec 2015
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Binding a dx2 spectrum transmitter
I have a dx2. spectrum transmitter with a sr200wp receiver. They came out of bind.I can bind them but servos won't work.I,ve tried to make them work a lot in the last 2 days, but nogo ,any ideas? Is there a different receiver that would be compatible with the dx2.0? I'm kind of stuck on this.Any info would be helpful as I am a noob at this.Thanks in advance ,Bob
Last edited by Justaddwata; 07-13-2017 at 07:46 AM. Reason: Original subject did not relate to subject
#2
Senior Member
Join Date: Nov 2010
Location: Tyler TX
Posts: 211
Likes: 0
Received 0 Likes
on
0 Posts
Is the rx and trans the same age? or is one dsm and the other dsmx? also have you tried a known good servo? just thoughts to try? I had thisd issue but it ended up the old rx I had wouldn't bind up with my new trans.
Ken
Ken
#7
My Feedback: (1)
I had a guy bring me a boat last year that had the same problem. It took me just a second to see the problem. I use the black (negative) wire to the outside as his were swapped around. Things were easier when all of the servos had the tabs on them like the Futaba's so they'd only go in one way. The older Airtronics though messed that up as they swapped the wires around.