MT 4.6 aftermarket wheels and tire suggestions
#2
Mattster
#5
Senior Member
Join Date: Sep 2015
Posts: 127
Likes: 0
Received 0 Likes
on
0 Posts
Hope you are taping them ....mgt gots power so trenchers will balloon to about 9inches..
I have a set on my xtm mammoth,lst,pedes,sc10rs etc..the bigger guys got the trencher x and love them.
I have a set on my xtm mammoth,lst,pedes,sc10rs etc..the bigger guys got the trencher x and love them.
#7
Senior Member
Join Date: Sep 2015
Posts: 127
Likes: 0
Received 0 Likes
on
0 Posts
Depends
Are you dirt only grass mud street gravel if yes trenchers but you got X and then you got standard.
If you are hardcore off road badlands
Some like big Joe's and they are ok..
They also make tsl swampers and they are gripy but sidewalls give out on the street on hard turns..
Are you dirt only grass mud street gravel if yes trenchers but you got X and then you got standard.
If you are hardcore off road badlands
Some like big Joe's and they are ok..
They also make tsl swampers and they are gripy but sidewalls give out on the street on hard turns..
#11
this is an old thread so the original people may or may not come back to respond.
either way i am sort of in the same boat, have one MGT with the 23mm hex adapters and the other with 14mm hexes. going to stick with the 14mm for now.
let me know what you end up with!
#12
The main problem in mgt and thunder tiger s28-s50 with 14-23mm hex hubs is that universal shafts are 6mm thick.Also the hole of the shaft is way in and you can't fit hubs like this which are the most you can find..
You can only use hubs like this.
Part number is Integy C23101S.There are two options for different offset +6mm +12mm and two different colors.I chose silver +6mm because I didn't want to widen the truck.
You need to use spacers inside the hub retainer to tighten because the washers come with are not thick enough and whole hub come out of the steel pin.
I used Bushings 5x8x2.5mm (Traxxas 3775).
You can only use hubs like this.
Part number is Integy C23101S.There are two options for different offset +6mm +12mm and two different colors.I chose silver +6mm because I didn't want to widen the truck.
You need to use spacers inside the hub retainer to tighten because the washers come with are not thick enough and whole hub come out of the steel pin.
I used Bushings 5x8x2.5mm (Traxxas 3775).
Last edited by 4kinitos; 02-19-2019 at 03:21 PM.
The following users liked this post:
rabidfox50 (04-06-2020)
#14
If you mean the bushings Traxxas 3775 I just put them with the washers in red cycle before the screws in the green cycle because the axle shafts are too long and the nuts doesn't go all the way in to keep the hubs and I had no problem.
The following users liked this post:
rabidfox50 (04-06-2020)
The following users liked this post:
4kinitos (04-06-2020)