Micro light profile
#54
Thread Starter
Join Date: Nov 2010
Location: Coffs Harbour NSW, AUSTRALIA
Posts: 1,650
Likes: 0
Received 72 Likes
on
68 Posts
The fully completed cut out frame now painted is ready for covering with use of 2 micron clear foil, keeping the weight to minimum. All electronics are ready to install in after the frame is assembled so it won't take long to get it ready for flying action.
New microlight frame ready for coverings.
New microlight frame ready for coverings.
#57
Thread Starter
Join Date: Nov 2010
Location: Coffs Harbour NSW, AUSTRALIA
Posts: 1,650
Likes: 0
Received 72 Likes
on
68 Posts
Just finished so far, my largest and lightest 1S powered Coaxial design for further indoor fun, "Yellow Swallow", as a new challenge to keep the weight to minimum. 3' by over 4 feet long spinning counter rotating just under 18" props. To check the CG I took it out this morn in free still air, happy as could be with the result.
Ready for its maiden to check the best battery position.
More than happy with the result.
Size comparison next to my "Black&Yellow" design.
Ready for its maiden to check the best battery position.
More than happy with the result.
Size comparison next to my "Black&Yellow" design.