Matched blade sets
#1
Member
Thread Starter
Join Date: Dec 2003
Location: Cedar Rapids, IA,
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
Matched blade sets
When I break a main rotor blade, I have been pulling a blade from a replacement set. I balance that blade with the original non-broken one, both CG and total weight. I figure I can save a few $$ this way. Is this a good or bad idea? Does it really matter that the blades did not come from the same package?
#2
Member
Join Date: Dec 2003
Location: redford, MI
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
RE: Matched blade sets
I don't think it matters that much, I mean yeah you're going to have to find cg on both and then put the tape on one of them...I just got done doing that for the first time, seems to have worked pretty good, almost no vibration on start up, once past a certain point it's rock solid. I did order carbon fiber blades from helihobby, supposedly pre balanced, I'll let you know when I get 'em.