Trim Sabre
#1
Senior Member
Thread Starter
Join Date: Oct 2002
Location: Chatham, UNITED KINGDOM
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
Trim Sabre
Hi All
I just wondered if any of you guy's that have built the Trim Sabre had problems finding
a pilot that fits, I'm in the middle of putting the scale cockpit together and I m finding that
the pilots are too high!!!.
Can you tell me what pilot you used and where I can get one.
Also I am fitting Futaba S9402 servo's for the flaps,I just wondered if its a case of swapping pot and motor
connections to reverse one of them.
Hope someone can help me on this
Thanks
Tony
I just wondered if any of you guy's that have built the Trim Sabre had problems finding
a pilot that fits, I'm in the middle of putting the scale cockpit together and I m finding that
the pilots are too high!!!.
Can you tell me what pilot you used and where I can get one.
Also I am fitting Futaba S9402 servo's for the flaps,I just wondered if its a case of swapping pot and motor
connections to reverse one of them.
Hope someone can help me on this
Thanks
Tony
#2
My Feedback: (11)
RE: Trim Sabre
I'm using one of the CJM pilots in the full cockpit in my Sabre. I don't remember the scale size I bought though. They sell just about every size. Also, I "bent" the legs a little to fit based on the advice of CJM by using a heat gun.
Here is the link:
http://www.centuryjet.com/webstore/c...fm?Category=42
Click on Combat Pilots at the bottom of the web page.
Here is the link:
http://www.centuryjet.com/webstore/c...fm?Category=42
Click on Combat Pilots at the bottom of the web page.