Scalloped MonoKote finish
#2
RCU Forum Manager/Admin
My Feedback: (9)
RE: Scalloped MonoKote finish
ORIGINAL: Arthur_GA
scalloped Monokote finishes like on a Gee Bee.
Thanks!
scalloped Monokote finishes like on a Gee Bee.
Thanks!
#4
My Feedback: (20)
Join Date: Feb 2005
Location: memphis ,
TN
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
RE: Scalloped MonoKote finish
I used a coffe can one time to make the scalops, I drew a line on the monokote,approx 6-8" away from where the LE would be, then would put half the coffecan on that line and draw around it with a felt tip pin, then cut out free hand.
Hope this helps
Hope this helps
#5
RCU Forum Manager/Admin
My Feedback: (9)
RE: Scalloped MonoKote finish
You can use just about anything to draw a circle to get that design. A good point is to turn your monokote over and draw on the backing, and then cut your design out. Another option is to go to the sewing department of Wal-mart. the sell a circle cutter there. It's a large wheel with holes in it. You get a blade tool that will fit into the holes to cut your circle with.
Hope this helps
Hope this helps
#8
Senior Member
Join Date: Nov 2002
Location: RCHill,
NJ
Posts: 2,981
Likes: 0
Received 0 Likes
on
0 Posts
RE: Scalloped MonoKote finish
Here are a few pics from my scractch built Lazy Ace..Is this what you mean?
Very nice plane dude if only I had the time...................