Where does the tape go on the Foreplay?
04-20-2005, 08:20 AM
#1
Thread Starter
My Feedback: (34)
Join Date: Feb 2002
Location: Newnan,
GA
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
Where does the tape go on the Foreplay?
Chip, I read your post on installing the kevlar string, but you didn't mention the fiber tape. The directions aren't clear about where it goes. Is the tape necessary and where should I put it? Thanks.
Vince
Vince
04-20-2005, 05:12 PM
#2
Senior Member
My Feedback: (1)
Join Date: Apr 2004
Location: W.R.,
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
RE: Where does the tape go on the Foreplay?
http://www.rcuniverse.com/forum/Fore...2823165/tm.htm
I had the same Question On the middle of this page you can find this thread. hope this helps. This months 3 DFLYER Magazine has an article on the 4 Play Kool foimie I think you'll like yours.
greg
I had the same Question On the middle of this page you can find this thread. hope this helps. This months 3 DFLYER Magazine has an article on the 4 Play Kool foimie I think you'll like yours.
greg
04-23-2005, 11:51 AM
#3
My Feedback: (8)
RE: Where does the tape go on the Foreplay?
The tape runs parallel to the fuse in 3 spots on each wing. The top wing has the tape on the top over each end strut and in the ceter, and the bottom wing has the same 3 peices just on the bottom of the wing. The tape just keeps the thread from pulling through.
Chip
Chip
ORIGINAL: VinceY
Chip, I read your post on installing the kevlar string, but you didn't mention the fiber tape. The directions aren't clear about where it goes. Is the tape necessary and where should I put it? Thanks.
Vince
Chip, I read your post on installing the kevlar string, but you didn't mention the fiber tape. The directions aren't clear about where it goes. Is the tape necessary and where should I put it? Thanks.
Vince
