JR XS3 Install+servo help needed
#1
Junior Member
Thread Starter
Join Date: Sep 2005
Location: STANHOPE,
NJ
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
JR XS3 Install+servo help needed
I have a revo with opti drive and forward and reverse still hooked up, I just purchased thew JR XS3, I did the single steering mod with a HiTech 945 mg servo, I put one of the servos that came with the radio in for the throttle\brake servo JR Z590M, My question is how do I connect all of this, Do I need to by a Y harness and do you know the part # for it.
Any help would be cool
Johnny
Any help would be cool
Johnny
#2
Join Date: Nov 2004
Location: St. Thomas, ON, CANADA
Posts: 2,088
Likes: 0
Received 0 Likes
on
0 Posts
RE: JR XS3 Install+servo help needed
Should be a straight connect. Plug the steering into ch 1, throttle/brake into ch 2, reverse servo(or optidrive, i'm not sure how that works) into ch 3 and the switch/battery into Batt.
If the servo leads have the fin on them that makes it so you can't fit it into the receiver, use some side cutters and clip that fin off.
If the servo leads have the fin on them that makes it so you can't fit it into the receiver, use some side cutters and clip that fin off.