how to install rx and batt in wing
12-20-2005, 05:48 PM
#1
Member
Thread Starter
My Feedback: (95)
Join Date: Apr 2004
Location: Lenzburg,
IL
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
how to install rx and batt in wing
O.K. builders do any of you have pics on how you did the Rx, and battery install in the wing of the Katana 46 profile planes...did not rec. a owners manual with the plane..and could use a little help with the Rx/batt wing installation...a pic is worth a thousand dollars..woops I meant words....this is my first profile plane with the Rx and Batt being put in the wing...Thank you in advance for your help......V.Rap
12-21-2005, 07:38 AM
#2
Senior Member
My Feedback: (47)
Join Date: Aug 2002
Location: Suwanee,
GA
Posts: 1,052
Likes: 0
Received 0 Likes
on
0 Posts
RE: how to install rx and batt in wing
I'm not sure if you got my email about the batt. and RX what I ussualy do with all my planes I cut 1/4'' foam the sise of the rx and I glue it to the wing then I use heat shrink and wrap arround the Rx then I glue th RX to the foam,,, when you need to take it out just cut the heat shrink and you have a clean RX again,, same with the battery,,,, if you don't hace heat shrink that sise which is the one to make batteries you can just use scotch tape.
I make the foam double 2 1/4'' foam glue togeather,,, and when you glue the RX or battery to it they are like floating on top of the Foam!!! make sure you don't put the battery on the same side as the engine to keep the lateral balance =
Good luck I'll take some pics tonight!!!
I make the foam double 2 1/4'' foam glue togeather,,, and when you glue the RX or battery to it they are like floating on top of the Foam!!! make sure you don't put the battery on the same side as the engine to keep the lateral balance =
Good luck I'll take some pics tonight!!!
