Wing Servos
#1
Senior Member
Thread Starter
My Feedback: (9)
Join Date: Aug 2002
Location: Apopka,
FL
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Chipmunk
I believe the original setup for the Goldberg Chipmunk was with one servo in the center section of the wing with linkage and bell cranks out to the control surfaces.
#2
Senior Member
Thread Starter
My Feedback: (9)
Join Date: Aug 2002
Location: Apopka,
FL
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Wing Servos
Hitech makes some nice low profile servos for airlerons. I think you will find that the chipmunk wing thickness is pretty thin at the point were you will have to mount them.
#3
Senior Member
Join Date: Jun 2002
Location: Plover,
WI
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
Super Chipmunk, need information
Hockey Pilot, I have the original plans yet. The original plans don't really show the complete formers, just the position that they sit in. You should be able to get measurments off the 3d drawings enough to make your own. The fuse sides would be no problem. PM me and I would be willing to send you the original to BORROW! for a copy at your local copy center. (Carl Goldberg, you didn't read this)