HELP-stab incidence on H9 Cap 232 is +1/2
12-07-2002, 01:22 AM
#1
HELP-stab incidence on H9 Cap 232 is +1/2
My H9 Cap 232 25% is done, but I got a problem.
My stab is + 1/2 degree on the incidence. Wing and motor are set at 0.
Is this a BIG problem or can I fly it like this?
Only way to fix it is to shim the trailing edge of the wing and add shims to the engine mount.
I flew the plane today. Two short flights (8 minutes) without any problems. Plane rolls very well, with no wobbling of the tail. Loops were clean without any snapping out. Two clicks of down elevator trim and it was flying level.
Thanks
My stab is + 1/2 degree on the incidence. Wing and motor are set at 0.
Is this a BIG problem or can I fly it like this?
Only way to fix it is to shim the trailing edge of the wing and add shims to the engine mount.
I flew the plane today. Two short flights (8 minutes) without any problems. Plane rolls very well, with no wobbling of the tail. Loops were clean without any snapping out. Two clicks of down elevator trim and it was flying level.
Thanks
