Correct MVVS for Cap X
#1
Senior Member
Thread Starter
My Feedback: (13)
Join Date: Jun 2004
Location: Merced, Ca.,
CA
Posts: 2,118
Likes: 0
Received 0 Likes
on
0 Posts
Correct MVVS for Cap X
Dar:
Looking for a good gas match for new Cap X, is 73" span, 13-15 lb, intended for 3-D. Currently have one with ZDZ 40, power is very good here. Want to avoid the install hastle, the MVVS appears a good direction. Do you have a suggested engine for this combo, do love power!
Looking for a good gas match for new Cap X, is 73" span, 13-15 lb, intended for 3-D. Currently have one with ZDZ 40, power is very good here. Want to avoid the install hastle, the MVVS appears a good direction. Do you have a suggested engine for this combo, do love power!
#2
Senior Member
RE: Correct MVVS for Cap X
Roger,
The MVVS 35 cc engine would give this model 'scale' power.
However, for 3-D and since your other such plane has the ZDZ 40 cc, I would suggest the MVVS 45 MG for it.
It is very light and will out-power your other model by a very significant margin.
The MVVS 45 cc has a very low level of vibration.
You can go to the [link=http://www.mvvs.cz/]MVVS web site[/link].
Select 'Galerie' on the left then select 'Videogalerie' at the top.
The top clip visualizes this engine running.
The MVVS 35 cc engine would give this model 'scale' power.
However, for 3-D and since your other such plane has the ZDZ 40 cc, I would suggest the MVVS 45 MG for it.
It is very light and will out-power your other model by a very significant margin.
The MVVS 45 cc has a very low level of vibration.
You can go to the [link=http://www.mvvs.cz/]MVVS web site[/link].
Select 'Galerie' on the left then select 'Videogalerie' at the top.
The top clip visualizes this engine running.