Putting the wires for navigation LEDs into rods
#1
Junior Member
Thread Starter
Join Date: Apr 2006
Location: Seoul, KOREA, REPUBLIC OF (KOR)
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Putting the wires for navigation LEDs into rods
Hi,
Has anyone succeeded in putting the wires for navigation LEDs into the carbon rods?
I measured the sizes of the carbon rods as follows.
Outer diameter : 5mm
Inner diameter : 3mm
Thanks,
K.J. Woo
Has anyone succeeded in putting the wires for navigation LEDs into the carbon rods?
I measured the sizes of the carbon rods as follows.
Outer diameter : 5mm
Inner diameter : 3mm
Thanks,
K.J. Woo
#2
My Feedback: (40)
Join Date: Dec 2002
Location: Saskatoon,
SK, CANADA
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
RE: Putting the wires for navigation LEDs into rods
Off topic,
KJ, have you dealt with X-Copter in Seoul? They are stocking our Draganflyer and Draganflyer parts.
Adam Glatt
Draganfly Innovations
KJ, have you dealt with X-Copter in Seoul? They are stocking our Draganflyer and Draganflyer parts.
Adam Glatt
Draganfly Innovations
#3
Junior Member
Thread Starter
Join Date: Apr 2006
Location: Seoul, KOREA, REPUBLIC OF (KOR)
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
RE: Putting the wires for navigation LEDs into rods
Off topic;
Yes, I know them. They are very kind and ready to help us.
But some draganfly parts are out of stock now.
K.J. Woo
Yes, I know them. They are very kind and ready to help us.
But some draganfly parts are out of stock now.
K.J. Woo
#4
Senior Member
Join Date: Dec 2005
Location: Atlanta,
GA
Posts: 1,514
Likes: 0
Received 0 Likes
on
0 Posts
RE: Putting the wires for navigation LEDs into rods
Woorie, good luck trying to get any more wires in that little bitty CF tube. I have just routed my wires along the top of the tube and then covered them with black electrical tape, not by wrapping but just by laying the tape lengthwise so it covers the wiring but only covers half the tube. This way it covers the wires and is easy to remove if I need to change something.