Tie rod length
09-28-2006, 04:58 PM
#1
Member
Thread Starter
Join Date: Aug 2005
Location: Aurora,
ON, CANADA
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Tie rod length
I may have answered my own question, but I thought I would run it by you more experienced guys first. When you set up your tie rods for toe, the front steering two should be the exact same length and your rear two should be the exact same length right? Then adjust your steering trim to straighten up your front wheels right? The reason I ask is that my two fronts are different lengths from out of the box and I noticed in the manual they are supposed to be the same.
Any help?
Any help?
09-28-2006, 05:32 PM
#2
Senior Member
My Feedback: (3)
Join Date: Feb 2005
Location: Westmont, NJ
Posts: 1,180
Likes: 0
Received 0 Likes
on
0 Posts
RE: Tie rod length
You got it...
Make sure that your servo horn and steering trim is centered first though.
What I do is is take the horn off the servo and power on the TX & RX. I then center the so it's at 90* and then put the horn back on.... Only then do I adjust turnbuckles.
Make sure that your servo horn and steering trim is centered first though.
What I do is is take the horn off the servo and power on the TX & RX. I then center the so it's at 90* and then put the horn back on.... Only then do I adjust turnbuckles.
