iraqvet

I saw a tip on using an awl to insert servo bushings in the rubber grommets but found my Craftsman quick release drill bits work well and hold several bushings making the job quick and easy! Slip the bushings on the bit an push them into the grommets...also work with a jewelers screwdriver...

RRW_SOAR

Very nice tip, thank you for your help.

Kaos Rulz

The simple ideas are great ideas. I just wish I had thought of it, especially when I have a couple of sets of these drill bits within reach as I fumble with inserting the grommets using the old-fashioned thumbing method. [:@]
Thanks iraqvet.

tailskid

My Feedback: (34)

Thanks for the tip! Sometimes I think the OD of the eyelet is larger than the hole in the grommet!

Ugo Ferrari

My Feedback: (1)

Geeze. Fellows... Just use a PENCIL ! Keep it SIMPLE !
Ugo

MinnFlyer

My Feedback: (4)

I use a jeweler's screwdriver