Failsafe mounting position
06-11-2007, 04:14 PM
#1
Member
Thread Starter
Join Date: May 2007
Location: citrus springs, FL
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Failsafe mounting position
I ordered a duratrax failsafe today after switching to the foc on the advice of people from this forum (thanks). Anyhow, I was thinking of mounting the failsafe neatly inside the receiver box instead of on the outside. Does anyone see a problem with this? Am I gonna have to access it on a daily basis after setup? Thanks.
06-11-2007, 04:35 PM
#3
Senior Member
My Feedback: (1)
Join Date: Dec 2003
Location: Monee, IL
Posts: 1,341
Likes: 0
Received 0 Likes
on
0 Posts
RE: Failsafe mounting position
It should fit in the receiver box depending on how big it is? Why will need to have access to it on a daily basis? Once you have it set the way you want you don't have to touch it again. I have mine set so it applies light to medium brake so it comes to a stop without flipping.
06-11-2007, 05:06 PM
#4
Senior Member
Join Date: Feb 2007
Location: thousand oaks,
CA
Posts: 1,669
Likes: 0
Received 0 Likes
on
0 Posts
RE: Failsafe mounting position
a revo or t-max? if revo, this is where i mount my FS. i attach it to the receiver using Velcro. it gets dirty sometimes but i just wipe the top with my finger.
06-11-2007, 06:26 PM
#7
Member
Thread Starter
Join Date: May 2007
Location: citrus springs, FL
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
RE: Failsafe mounting position
It's a tmaxx 3.3. Looks like i'll go with putting neatly inside the receiver box since the optidrives out and I have a cover for it from the foc kit. THANKS ALL!!!!
