Monokote Covering Question
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Jan 2005
Location: Lincoln,
NE
Posts: 472
Likes: 0
Received 0 Likes
on
0 Posts
Monokote Covering Question
Ok, so what's the secret decoder ring password voodoo method that those ARF builders use to get perfect looking covering on compound curves?
I'm repairing the end of a Pitts wing, and the compound curve is a wrinkle-producing compoud curve.
Yeah, I'm sucky at covering, but the ARF builders (who cover planes 8 hrs a day or more) make it look easy.
A little help?
[]
I'm repairing the end of a Pitts wing, and the compound curve is a wrinkle-producing compoud curve.
Yeah, I'm sucky at covering, but the ARF builders (who cover planes 8 hrs a day or more) make it look easy.
A little help?
[]
#2
Senior Member
RE: Monokote Covering Question
Years and years of practice. I know many modelers that can do a far superior covering job than any ARF I've seen. Then again, they have been covering for 30 or 40 years.
I'm almost as good at covering as some ARFs, so perhaps I can help. Most people don't realize that Monokote stretches also. You need the stretching quality for wrinkle-free compound curves. I use the heat gun to pull and stretch the covering around the wingtip. Careful, there's a fine line between enough heat and blowing a hole in the wing covering. once you go past halfway on the first side cut the covering where it's already stuck, so you don't get wrinkled fringes. Repeat on the other side. Trimming is more difficult on the second side because the covering must overlap and be cut without cutting through the first piece. Stretch the covering until it overlaps and then cut the covering just barely past where its stuck down so you don't get a series of waves or wrinkles. Use an iron and carefully roll down the seam. I also use Ultracote which IMHO is slightly better at shrinking and stretching than Monokote.
Minn-Flyer also has a great series of video tutorials on RCUniverse.
I'm almost as good at covering as some ARFs, so perhaps I can help. Most people don't realize that Monokote stretches also. You need the stretching quality for wrinkle-free compound curves. I use the heat gun to pull and stretch the covering around the wingtip. Careful, there's a fine line between enough heat and blowing a hole in the wing covering. once you go past halfway on the first side cut the covering where it's already stuck, so you don't get wrinkled fringes. Repeat on the other side. Trimming is more difficult on the second side because the covering must overlap and be cut without cutting through the first piece. Stretch the covering until it overlaps and then cut the covering just barely past where its stuck down so you don't get a series of waves or wrinkles. Use an iron and carefully roll down the seam. I also use Ultracote which IMHO is slightly better at shrinking and stretching than Monokote.
Minn-Flyer also has a great series of video tutorials on RCUniverse.
#3
RCU Forum Manager/Admin
My Feedback: (9)
RE: Monokote Covering Question
ORIGINAL: Nathan King
Minn-Flyer also has a great series of video tutorials on RCUniverse.
Minn-Flyer also has a great series of video tutorials on RCUniverse.
[link=http://www.rcuniverse.com/magazine/article_display.cfm?article_id=67] Minnflyer Covering how-to [/link]
[link=http://www.rcuniverse.com/magazine/article_display.cfm?article_id=726] Minnflyer, Another Look at Covering[/link]