Zenoa G26 dimensions???
#1
Thread Starter
My Feedback: (37)
Zenoa G26 dimensions???
Does anyone have a drawing of a G26 or even a G23? I am trying to see if this fits my airplane I am building. Heck if someone lives near Burbank, CA . I would even take a short drive to measure it up. Here are some of the dimensions that I am looking for....
-top of the head to the top of the plug cap
-top of the head from the center shaft
-the prop drive shaft to the front cylinder head
-cylinder head width
-the prodrive shaft to the engine mount plate (firewall)
-distance of the carb from the head or from the center shaft.
Thanks for any help you can offer...
Vic
-top of the head to the top of the plug cap
-top of the head from the center shaft
-the prop drive shaft to the front cylinder head
-cylinder head width
-the prodrive shaft to the engine mount plate (firewall)
-distance of the carb from the head or from the center shaft.
Thanks for any help you can offer...
Vic
#3
Member
My Feedback: (2)
Join Date: May 2002
Location: Longmont,
CO,
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
Zenoa G26 dimensions???
Or you can download the entire Zenoah manual at:
http://horizon.hobbyshopnow.com/shar...nfo/zeneng.pdf
http://horizon.hobbyshopnow.com/shar...nfo/zeneng.pdf
#4
Thread Starter
My Feedback: (37)
Zenoa G26 dimensions???
rmteo1 thanks I download the pdf!
I searched this forum and found the G26 thread (the mother of all G26 threads)
Again RCIGN thanks for many clarifications... I think I will go with the G26 for my P38. By the way, will you be at the Castle Fly-in this year?
Vic
I searched this forum and found the G26 thread (the mother of all G26 threads)
Again RCIGN thanks for many clarifications... I think I will go with the G26 for my P38. By the way, will you be at the Castle Fly-in this year?
Vic