Zenoah Exhaust port Bolt Dimensions...
#1
Senior Member
Thread Starter
Join Date: Aug 2005
Location: Winnipeg,
MB, CANADA
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
Zenoah Exhaust port Bolt Dimensions...
What is the dimention of center to center on the exhaust bolts on a zenoah G260 marine?
Also what is the approximate size of the port? X by X
Also what is the approximate size of the port? X by X
#2
Senior Member
My Feedback: (48)
Join Date: Mar 2003
Location: Gulf Shores, AL
Posts: 1,885
Likes: 0
Received 0 Likes
on
0 Posts
RE: Zenoah Exhaust port Bolt Dimensions...
ORIGINAL: nofords
What is the dimention of center to center on the exhaust bolts on a zenoah G260 marine?
What is the dimention of center to center on the exhaust bolts on a zenoah G260 marine?
If I had one nearby, I'd get the measurements for you.
#3
Senior Member
Thread Starter
Join Date: Aug 2005
Location: Winnipeg,
MB, CANADA
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
RE: Zenoah Exhaust port Bolt Dimensions...
Ahh, i would assume that to be true aswell except I do not own a Zenoah at all! I thinking using zenoah parts on another engine brand. all of the zenoah engine diagrams do not give this dimension.
#6
Senior Member
Join Date: Feb 2007
Location: Newcastle, UNITED KINGDOM
Posts: 1,385
Likes: 0
Received 0 Likes
on
0 Posts
RE: Zenoah Exhaust port Bolt Dimensions...
Right,
roughly (vernier caliper rough - and a few pints on board) here are the dimensions:
BTWN ctrs on fixing bolts: 34.4mm
X dimension is approximately 12mm
Whilst Y is approximately 21.5mm
Hope this is useful.
Glenn
roughly (vernier caliper rough - and a few pints on board) here are the dimensions:
BTWN ctrs on fixing bolts: 34.4mm
X dimension is approximately 12mm
Whilst Y is approximately 21.5mm
Hope this is useful.
Glenn
#9
Senior Member
Thread Starter
Join Date: Aug 2005
Location: Winnipeg,
MB, CANADA
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
RE: Zenoah Exhaust port Bolt Dimensions...
Another tough question that i didn't think of before...
How far off center are the bolt holes in relation to the port???
How far off center are the bolt holes in relation to the port???