Enforcer Hardware setup ?'s
05-26-2008, 10:27 PM
#1
Member
Thread Starter
Join Date: Apr 2007
Location: livermore, CA
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Enforcer Hardware setup ?'s
So I'm about to mount my engine but I realized I forgot how my hardware setup bolts on. I bought this set about a year ago and am just now finding the time to put it together. I took some pictures of the setup and the number or product code I think it is. If anybody could help me figure out if the shaft goes through the bottom of the hull or straight out the back would be great. Thanks for any help!
05-26-2008, 10:53 PM
#2
Senior Member
Join Date: Apr 2007
Location: williamston,
SC
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
RE: Enforcer Hardware setup ?'s
Contact [link=http://whobbies.com/]WHH[/link]. Looks like a XP drive. Tony will help you out, or you can look at the pics of it on the site and see how it fits up.
It can be set up to exit the transom for a surface drive, or the bottom of the hull for subsurface. The choice is yours.
It can be set up to exit the transom for a surface drive, or the bottom of the hull for subsurface. The choice is yours.
05-26-2008, 11:46 PM
#3
Member
Thread Starter
Join Date: Apr 2007
Location: livermore, CA
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
RE: Enforcer Hardware setup ?'s
ok that helps alot thanks! what is usually better then surface or subsurface? what's the advantage of one over the other?
