tmaxx 3.3 won't shift into second
#1
Junior Member
Thread Starter
Join Date: Sep 2008
Location: , TX
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
tmaxx 3.3 won't shift into second
it was working fine earlier today ,but now it just stays in first. The tuning is good its not too rich so I know thats not the problem. i'm stumped
#2
Senior Member
Join Date: Jul 2005
Location: Torchy the Fiery Fast RC Turtl
Posts: 10,544
Likes: 0
Received 0 Likes
on
0 Posts
RE: tmaxx 3.3 won't shift into second
Check out this thread, the guy even took apart his tranny to see what he needed to do.
http://www.rcuniverse.com/forum/m_7972209/tm.htm
http://www.rcuniverse.com/forum/m_7972209/tm.htm
#3
Senior Member
RE: tmaxx 3.3 won't shift into second
Its probably either the set screw is not out enough turns or something in the trans is outta whack from the sounds of it, but follow that thread that Jim posted the link to and hopefully that will point ya in the right direction....
#4
Member
Join Date: Feb 2008
Location: , OH
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
RE: tmaxx 3.3 won't shift into second
haha thats my post.lol
make sure the one grub screw is tight on the shaft and tighten the shift point grub screw all the way and back it out 7 times.i also put the carb screws back to factory specs...lsn closed,then 1.5-1.7 turns out..hsn close then 4 turns out.thats what i did and everything works perfect now..hope this helps out.good luck
make sure the one grub screw is tight on the shaft and tighten the shift point grub screw all the way and back it out 7 times.i also put the carb screws back to factory specs...lsn closed,then 1.5-1.7 turns out..hsn close then 4 turns out.thats what i did and everything works perfect now..hope this helps out.good luck