How do I clean my engine internally?
06-08-2003, 09:20 PM
#1
Senior Member
Thread Starter
Join Date: May 2003
Location: AZ
Posts: 204
Likes: 0
Received 0 Likes
on
0 Posts
How do I clean my engine internally?
Hi, I was just wondering how I would go about cleaning my engine internally.. Is there anything I can run through it to clean it?? Thanks
06-08-2003, 09:26 PM
#2
Senior Member
Join Date: May 2003
Location: STROUDSBURG ,
PA
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
How do I clean my engine internally?
The one thing I know of, I believe its called After run. Cleans all of the left over mung out and prevents the nitro from turning into gum.
06-08-2003, 10:23 PM
#5
Senior Member
Thread Starter
Join Date: May 2003
Location: AZ
Posts: 204
Likes: 0
Received 0 Likes
on
0 Posts
How do I clean my engine internally?
I don't think so I was just curious on how it would be done just in case I get sand in it by accident, (I drive it in the desert).
06-08-2003, 10:35 PM
#6
How do I clean my engine internally?
If you get sand in your engine, stop it immediately and take it to your local hobby shop to be dismantled and cleaned if you aren't comfortable doing it yourself. There's nothing you can run through it to get sand or grit out without damaging the piston and sleeve, along with the bearings.
06-09-2003, 12:33 AM
#11
Senior Member
My Feedback: (1)
Join Date: Aug 2002
Location: Fort Worth Tx
Posts: 1,664
Likes: 0
Received 0 Likes
on
0 Posts
How do I clean my engine internally?
no, dont pull the pull start dude, take it apart and spray everything out with WD 40, if you pull it around, you are going to scrape the sand and whatever else up against the P/S and it will scar the sides of it. That will eventually cause premature engine failure.
06-09-2003, 07:47 AM
#12
Member
Join Date: Feb 2003
Location: adelaideSouth Aus, AUSTRALIA
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
How do I clean my engine internally?
he hasnt got sand in it yet have you!! if u use a good air fiter and run it with a body and clean the airfilter reguarly it should be fine just give it a squirt of wd40 and give it a couple of tugs
