vett

My Feedback: (37)

Just started the Flair F2b kit wow so far it is pretty nice just building the front fuse. section and everything fits perfectly the die cutting is fall out there are a lot of router cut parts and hardware I will post pictures as I progress

vett

My Feedback: (37)

here are the first pictures this is the bussiness end all parts fit is great I installed a 12 0z. tank but very easy to modifie for a 16oz> tank. [email protected]

vett

My Feedback: (37)

fuse framed up with stab no for the sanding and shaping it all went togather well just like a stick model.

vett

My Feedback: (37)

rear view

vett

My Feedback: (37)

TAIL SKID

vett

My Feedback: (37)

here is the tail section, elevator, h stab,fin, sub fin,rudder and radiator

vett

My Feedback: (37)

this is the upper left wing panal ailerons not cut yet it a little tricky to build because the instructions make you jump all over the place a nice feature is the round stock leadong edge. All the strut brakets are formed but must be modifided as per the instructions.

vett

My Feedback: (37)

the fuse. with center section mounted be carful with spacing of brackets it's a tight fit.

vett

My Feedback: (37)

up on the LG