OK Seduction Fun Fly ARC
06-11-2003, 08:29 PM
#1
Senior Member
Thread Starter
Join Date: Nov 2002
Location: Tyler, TX
Posts: 270
Likes: 0
Received 0 Likes
on
0 Posts
OK Seduction Fun Fly ARC
Has anybody seen/flown one of these?
It is featured an a new MAN review. Now, I know not to put too much stock in these reviews, but the AUW is listed at 3 lb 7 oz. An online review was favorable, so I ordered one.
Leonard
It is featured an a new MAN review. Now, I know not to put too much stock in these reviews, but the AUW is listed at 3 lb 7 oz. An online review was favorable, so I ordered one.
Leonard
06-14-2003, 03:54 PM
#3
Senior Member
Join Date: Mar 2002
Location: Cleveland,
MS
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
I have!
I have one. With a 46fx/tower pipe and APC 12 1/4 x 3 3/4 ready to fly it came in at 4lbs even. I have since added a little tail weight and 3 carbon fiber flat rods along the bottom for strength. It flies sooooooo slow, and very true. A little weak in the tail, but a little carbon fiber goes along way. I nosed it in coming out of a flat spin (The spin looked so good, I just kept it in way to long!) In about 15 minutes this plane could be flying again, It has hitec 225BBs all the way around, they go in the wing before it is covered, but now they are stripped. Thats the worst of the damage!
If you build one don't put 225BBs in it. The plane is many, many times tougher than this servo!
If you build one don't put 225BBs in it. The plane is many, many times tougher than this servo!
06-14-2003, 11:16 PM
#4
Senior Member
Thread Starter
Join Date: Nov 2002
Location: Tyler, TX
Posts: 270
Likes: 0
Received 0 Likes
on
0 Posts
OK Seduction Fun Fly ARC
A little weak in the tail
Leonard
06-15-2003, 02:41 AM
#5
Senior Member
Join Date: Mar 2002
Location: Cleveland,
MS
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
Oooops...
Yeah, I guess I should have made that clearer. THey actually have a piece of hardwood accross the horizontal that gives it plenty of strength. I really haven't seen the need for flying wires.
I ordered three carbon fiber strips and shaped them like c channel along the bottom of the plane. You really need to do something or it will break right behid the trailing edge of the wing.
I ordered three carbon fiber strips and shaped them like c channel along the bottom of the plane. You really need to do something or it will break right behid the trailing edge of the wing.
