Soldering deans connector
#1
Senior Member
Thread Starter
![Default](images/icons/icon1.gif)
My friends bought two LiPos and asked me to solder two deans connectors on it for him.
The wires are so big and the deans connectors are so small. It took me 1 hour trying to solder those big wires onto the gold contacts and soldering still doesn't look strong enough.
Any hints?
The wires are so big and the deans connectors are so small. It took me 1 hour trying to solder those big wires onto the gold contacts and soldering still doesn't look strong enough.
Any hints?
#2
Senior Member
Join Date: Nov 2005
Location: Southern California,
CA
Posts: 6,912
Likes: 0
Received 0 Likes
on
0 Posts
![Default](images/icons/icon1.gif)
Put a drop on flux on the gold tab, then use the solder from your soldering iron and put some on there to tin. Do that with the wire too. Then put some flux on both wires, put the heat shrink tubing on the wire, and press the soldering iron on the top of the wire so the heat goes onto the gold tap and the joint is formed. Pretty easy if you ask me.
#3
Senior Member
Join Date: Apr 2009
Location: CHICAGOLAND,
IL
Posts: 1,856
Likes: 0
Received 0 Likes
on
0 Posts
#5
Senior Member
Join Date: Aug 2007
Location: Edmonton,
AB, CANADA
Posts: 7,441
Likes: 0
Received 0 Likes
on
0 Posts
![Default](images/icons/icon1.gif)
A high heat soldering iron is best for a clean job but not necessary, I used to use a 45w and it worked fine. As suggested by Chris you need to pre-tin the connector and wires. Then place the wire on top of the connector, put the iron on top of the wire and press down. Once all the solder flows together you're done except for the heat shrink.
Important: only do one wire fully at a time, you never want to short a battery so place the heat shrink on a completed connection BEFORE you strip the other wire. Also, make sure you solder the positive wire to the tab with the + sign beside it.
Important: only do one wire fully at a time, you never want to short a battery so place the heat shrink on a completed connection BEFORE you strip the other wire. Also, make sure you solder the positive wire to the tab with the + sign beside it.
#6
Senior Member
Join Date: Oct 2005
Location: SAN DIEGO, CA CA
Posts: 1,063
Likes: 0
Received 0 Likes
on
0 Posts
![Default](images/icons/icon1.gif)
I roughen the connector first with a file or sandpaper, they seem to bond better this way, then I do same as what was said above.