Indestructible Carbon Fiber
#1
Member
Thread Starter
Join Date: Jun 2003
Location: Stillwater, MN
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Indestructible Carbon Fiber
im looking for a micro rs4 site that had a walkthrough on how to make carbon fiber almost indestructible and longer lasting. it was a page onvolving sanding the edges and then letting a bead of ca run down the edge. anyone got a link?
#3
Member
Thread Starter
Join Date: Jun 2003
Location: Stillwater, MN
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Indestructible Carbon Fiber
well i have a micro rs4 with a lot a carbon fiber and i was surfing the net and i found this one website where they did all this stuff to carbon fiber to make it last longer. and im trying to find anyone who might know the name to the site. i need to do it to my hpi rush otherwise the layers of cf will come apart.
#7
My Feedback: (11)
Join Date: Oct 2002
Location: Northridge, ON, CANADA
Posts: 4,419
Likes: 0
Received 1 Like
on
1 Post
Indestructible Carbon Fiber
The purpose for lightly sanding the edges and putting a thin layer of ca on the cut surfaces is to prevent delamination. I've done this for years.
Here's what you do.
Take a fine grit sandpaper or emery cloth (220 grit is fine).
Lightly sand the sides fo the graphite (or carbon fibre) parts (the cut edge).
Using thin ca, put a small film on the sanded edge.
Allow it to air dry.
Here's what you do.
Take a fine grit sandpaper or emery cloth (220 grit is fine).
Lightly sand the sides fo the graphite (or carbon fibre) parts (the cut edge).
Using thin ca, put a small film on the sanded edge.
Allow it to air dry.