dx6i settings for blade 400
04-02-2010, 06:32 PM
#1
Member
Thread Starter
Join Date: Dec 2006
Location: , MN
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
dx6i settings for blade 400
Could someone give me a list of all the dx6i settings for the blade 400. I have searched all over. I have a blade 400 with 3 hs65mg servos. It would really help alot.
04-02-2010, 08:06 PM
#2
Senior Member
Join Date: Feb 2009
Location: Gatineau,
QC, CANADA
Posts: 608
Likes: 0
Received 0 Likes
on
0 Posts
RE: dx6i settings for blade 400
When looking for transmitter settings, you can normally refer to the ARF manual rather than the RTF. Look at the manual starting at page 11 found on the Horizon Hobby support page for the Blade 400 ARF.
http://www.horizonhobby.com/Products...5#quickSupport
On the support page for the Blade 400 RTF, there is a link for basic DX6i setup (not as detailed):
http://www.horizonhobby.com/Products...0#quickSupport
Gilles
http://www.horizonhobby.com/Products...5#quickSupport
On the support page for the Blade 400 RTF, there is a link for basic DX6i setup (not as detailed):
http://www.horizonhobby.com/Products...0#quickSupport
Gilles
04-09-2010, 05:42 PM
#3
Junior Member
Join Date: May 2008
Location: Wichita,
KS
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
RE: dx6i settings for blade 400
There's also a good video that shows how to set the blade with slightly tamed down curves and other values...just an FYI:
[youtube]http://www.youtube.com/watch?v=PBXxAnSZWuc[/youtube]
[youtube]http://www.youtube.com/watch?v=PBXxAnSZWuc[/youtube]
04-09-2010, 06:17 PM
#4
Senior Member
Join Date: Nov 2009
Location: Glendale,
AZ
Posts: 1,034
Likes: 0
Received 0 Likes
on
0 Posts
RE: dx6i settings for blade 400
One thing to check is make sure your elevator arm and left aileron arm don't hit. Mine did when at full throttle and right aileron. I had to alter it to keep it from hitting.
