installing underbody lights
03-23-2010, 07:58 PM
#2
Moderator
RE: installing underbody lights
Depends how the lights are set up I guess, are they in strips? In any case some sort of plastic adhesive would work. If you want to spend more time and energy might be worth to make something removable. Underbody lights can be cool but I doubt you'd want them there during hard bashing.
03-24-2010, 12:10 AM
#4
My Feedback: (10)
Join Date: Nov 2009
Location: Sarasota,
FL
Posts: 627
Likes: 0
Received 0 Likes
on
0 Posts
RE: installing underbody lights
Try 3M Adhesive Velcro strips. I have a friend that puts that all inside his body and on the chassis and use that to keep his bodies on rather than use body clips. With that much strength, I would think that it would hold the lights fine and would be removable as was mentioned above about not using them while bashing.
If that doesn't work, perhaps you could drill a hole through the light strip itself and just anchor some screws to the chassis and you'd be able to remove it that way also.
Get creative, there are tons of ways you can get it to be on there.
Regards,
Rob
If that doesn't work, perhaps you could drill a hole through the light strip itself and just anchor some screws to the chassis and you'd be able to remove it that way also.
Get creative, there are tons of ways you can get it to be on there.
Regards,
Rob
