I put the K in KOS! (pics included)
#1
Senior Member
Thread Starter
Join Date: May 2006
Location: Bloomington,
MN
Posts: 296
Likes: 0
Received 0 Likes
on
0 Posts
I put the K in KOS! (pics included)
Done so far...
*Reinforced hull and strings with fiberglass, sealed the stock watercooling holes in left sponson, painted interior with Duplicolor bed liner paint.
*Reworked radio box, custom servo tray with carbon fiber vinyl, Dubro steering pushrods, WHH throttle cable.
*Futaba FASST 3PM-MX, Hobbico CS150 steering servo, Hobbico CS126 throttle servo, Duratrax 1600 6.0V.
*Stock engine with WHH 2" band tuned pipe, Silicone exhaust rings, Walbro WT-257 carb, WHH teflon carb gaskets, WHH neoprene water line.
*RCR Dual pickup rudder
*Single fuel line
Up Next...
* All WHH gear, M6 engine, driveshaft and 1/4" strut.
Still not sure what prop to spin. M6 has some high RPMs, thinking a 6519 or 6719. Not sure yet. Any suggestions?
*Reinforced hull and strings with fiberglass, sealed the stock watercooling holes in left sponson, painted interior with Duplicolor bed liner paint.
*Reworked radio box, custom servo tray with carbon fiber vinyl, Dubro steering pushrods, WHH throttle cable.
*Futaba FASST 3PM-MX, Hobbico CS150 steering servo, Hobbico CS126 throttle servo, Duratrax 1600 6.0V.
*Stock engine with WHH 2" band tuned pipe, Silicone exhaust rings, Walbro WT-257 carb, WHH teflon carb gaskets, WHH neoprene water line.
*RCR Dual pickup rudder
*Single fuel line
Up Next...
* All WHH gear, M6 engine, driveshaft and 1/4" strut.
Still not sure what prop to spin. M6 has some high RPMs, thinking a 6519 or 6719. Not sure yet. Any suggestions?